Armor course

This paper summarizes several ways to wear armor, which can be worn according to different occasions and needs. The tutorial is as follows:

Method 1: Paste with jelly glue.

Push down the dead skin on your hand with the inclined surface of the small wooden stick in the tool kit, so that the nail plate will be more obedient to your opponent. If your hands are too dry, you can soak them in warm water for a while. Then polish off the unevenness and excess grease on the nail surface with a file strip, and clean and disinfect the nail surface with alcohol cotton.

Choose the jelly glue suitable for the size of your nail surface, take the nail surface of the pavement as the standard, choose the big one instead of the small one, and stick it directly on the nail surface with the dust-proof film on it. Push from the middle to the side to expel the bubbles inside. After repeated pressing, remove the small film from the sticker. First put a nail paste on the root, then put it on the head, and then press it to discharge all the bubbles. Don't stick it askew. Don't touch the water or do anything for three hours after pasting.

Method 2: Use peelable primer and glue stick sticker.

This method requires a baking lamp. First, dig out a little glue stick and put it on the nail plate, and then flatten it with this rubbing strip. After flattening, buckle it directly on the nail, and then bake it under the baking lamp for about one minute.

Method 3: Use nail gel.

This method needs to use an ultraviolet lamp to scrape a little nail glue directly on the nail, which will be thinner. After pasting, it will be directly irradiated for about 60 seconds.