Matters needing attention in making beautiful seams at home

1, the joint filling place should be cleaned, and the residual impurities and dust will affect the adhesion.

2. The joint should be kept dry. Too wet is not conducive to adhesion and easy to collapse.

3. The section just extruded from sewing thread has poor viscosity and hardness, so it should be discarded.

4. Many tools are needed for sewing construction, such as hoses, glue guns, sewing cones, utility knives, towels, brushes, sewing balls, etc. These are all prepared in advance, and they are used only when they are found, which affects the progress.

Novices are always worried that the sewing material is not enough when they are in construction, and they are always willing to use the glue gun until the sewing material bulges in the gap. This gap is really full, but a lot of glue will be wasted when pressing the seam. If the gap is not deep, watch the sealant enter the gap and move the glue gun slowly.

Extended data operation steps

1. Use tools to clean and level off impurities that need to be filled with sealant.

2. Clean up these impurities and try not to leave dust.

3. Install sewing tools.

4. Cut out the glue mouth at an angle of 45 degrees.

5, pull the sewing tool gun, squeeze out about 40 cm of sewing glue and discard it.

6. Push the push rod spring to squeeze out the sewing agent and fill it into the gap.

7. Make a good shape and decorate it with sewing balls.

8. After the sealant is dry, shovel off the edge with a shovel.

9. The sewing agent is used up.