Water pipes are always dripping when they are broken. What are the economical and practical solutions?

First, if there is such a problem, it needs to be dealt with in time, but the cause of water leakage must be looked at when repairing. If the shaft pad of the faucet is worn, then we just need to change it with pliers at home.

Second, the solution of water pipe joint leakage: the water pipe joint at home is leaking, and the water pipe joint itself is broken, so it can only be replaced with a new one; Leaked threads can be removed. If there is no rubber pad, rubber pad should be installed, and the rubber pad is aging. Just put on a new one, coat the silk mouth with a thick layer of white paint, then wrap it in linen and put it on.

Thirdly, it is more difficult to solve the problem if it is glued or welded. If it is a problem with the faucet, it is caused by the wear of the shaft washer of the faucet. Loosen and remove the gland with pliers, remove the shaft seal with clamps, and replace it with a new shaft seal. After closing the valve core, the faucet still flows out. This phenomenon may be caused by loose pressure cover and loose sealing water valve core. The solution is to remove the handle and decorative cover, and then tighten the pressure cover again.

Fourth, another possibility is the valve. The rubber ring at the bottom of the iron core is deformed and cannot be sealed. The solution is to take out the valve core, check the rubber ring at the bottom, reset it and reinstall it. The phenomenon of water seepage around the valve core may be that the valve core is loose or displaced. The solution is to take out the valve core and reinstall it. There is water seepage in the middle of the valve core, which is the damage of the valve core. The solution is to replace the valve plug.

Water leakage at the bottom of the faucet is generally caused by incomplete filling or deformation of the O-ring of the water inlet pipe. The solution is to unscrew the hose. If the O-ring is not deformed, you will find the O-ring and the water inlet pipe. Change your sleeves. If the O-ring is deformed, please replace it.