How to design the inclined top of UG automobile mould?

Inclined top is generally used to shape the inner hook or outer hook of the product, and the side slider of the moving die can not be directly shaped, but also plays the role of ejecting the product. And when we draw automobile mold in ug software, how should we tilt the top? No, don't go away, children. The following are the design steps of UG automobile die inclined top. I hope everyone can understand by sharing the steps!

Design steps of UG automobile die inclined top;

1. When designing this type of inclined roof, we should pay attention to the following points: Because the draft angle of our inclined roof is 12 degrees, the angle of this plane of the inclined roof is 2 degrees larger than the ejection angle:

2. At this time, the design should pay attention to the design benchmark to facilitate the processing and positioning. The number of bumps is shown in the following figure:

3. Fixing method of inclined roof: straight ejector pin is used for fixing, as shown in the following figure:

4. Fixing method of inclined ejector pin: MISUMI standard parts are adopted for fixing.

5. Overall structure diagram:

The above five steps are about "how to design the inclined top of UG automobile mold?" I hope I can help you! Many friends may think that the tutorial is too simple and a lot of content is unclear. In fact, this tutorial is just a simple idea sharing. I hope everyone can learn better through their own independent thinking!