Must see! Check wooden doors and windows for home improvement at 5 o'clock.

Doors and windows should be square and cannot be warped and deformed. The door sash can just be inserted into the door sash frame and matched with the door sash frame: if the gap between the door sash and the frame is large, mainly because the plane is not allowed during installation or the door sash is not perpendicular to the ground, the door sash can be removed and planed again; If the door and window frames are not vertical, the gaskets in the frame plates should be aligned.

Wei Zi wood door west gate switch

1, the appearance should be beautiful: the paint film on the surface of wooden doors and windows should be smooth and bright, and there should be no quality defects such as sagging, bubbles, wrinkles, corrosion spots, dead joints and broken residues; The wood used for door and window covers should be in harmony with the wood and color of door and window sash. The color difference between decorative board and wood line should not be large, and the tree species should be the same.

2. Doors and windows should be square and cannot be warped and deformed. The door sash can just be stuffed into the door sash frame and matched with it. If the gap between the door sash and the frame is large, it is mainly because the plane is not allowed during installation or the door sash is not perpendicular to the ground, the door sash can be removed and planed again. If the door and window frames are not vertical, the gaskets in the frame plates should be aligned.

3. The hinge should be positioned accurately and installed firmly: if the hinge is not straight, it will lead to the mismatch between the door and window sash and the frame cover, and the door and window switch will not be smooth. You can unscrew a screw from each hinge first, then adjust the fit between the sash and the frame, and then tighten all the screws after adjustment and repair. If the hinge screw is short, or the screw is not screwed properly when it is screwed in, or the screw is inclined, it will lead to the deviation of the sash. Appropriate screws should be replaced and the screws must be straight. Screw in 1/3 first, and screw in the rest.

4. The door lock should be opened and locked smoothly, and the two parts locked on the door leaf and the door frame should be consistent: improper locking will lead to uncomfortable door leaf switch. The locking tongue piece should be removed, the tongue groove should be repaired with a chisel, and the position of the locking tongue opening of the door frame should be adjusted before installation. In addition, the opening direction of the door should also meet the requirements.

5. There should be base material in the door window cover: when the window cover is joinery board or density board, the base material board should be fixed on the base keel of the window frame first, and then the lines should be nailed; Door covers should be made of wood, planed and straightened, then assembled and installed on the wall, and then covered with base plates and decorative plates. Tap the side plate of the door and window cover by hand. If there is an empty drum sound, it means that there is no foundation board such as joinery board at the bottom, so it should be folded and redone.