How to make vases with DIY sprite bottles

I have seen many people's flower baskets made of plastic bottles, but I always feel that they are not detailed enough. So I decided to make a beautiful and practical flower basket with Sprite bottle on a boring afternoon. The main purpose is to hydroponic flowers. The tutorial is done while doing, so this time it is done in detail, and everyone will be able to learn it, and the practice is very simple, as long as you have enough patience.

Let's start with an renderings. I planted some cut bamboo, and it didn't take long to grow green leaves. As long as a little water moistens them, it is enough to make them behave well in Wan Fang. ?

This is done by the backstage of our particle counter department. Everybody loves it!

1. First prepare a sprite bottle or a coke bottle, but the transparent leaves may not be as beautiful as the green ones. I use 2.3L, which is relatively large, and it is more practical when growing flowers in water. )

2. Cut the top cover with scissors. Don't cut it too long, just cut it a little at the bend.

3. In order to be more accurate when cutting leaves in the future, you can draw a circle on the bottle body with a pen as a mark. Because I didn't find the water-based pen, I took the electrical tape wrapped around the faucet and wrapped it around the bottle. You can also use transparent glue.

The blade has been cut. Please look at the picture below and start cutting. One circle will cut about 10 pieces. And there is no need to trim the leaves in a hurry. This step will be completed in the end. All you have to do is cut out the outline of the blade.

5. After cutting the leaves, press the branches of the leaves first.

6. After cutting the leaves, don't cut the remaining plastic, and start cutting the second layer of leaves.

7. By analogy, leaves of about 10 can also be cut on the second floor.

8. This is the third layer blade. We will cut off the remaining plastic of the second layer blade to cut the third layer blade. Each floor is smaller than the next, so we need patience. We can cut the blade directly without cutting from the middle. Where do you think I can cut the blade beautifully or conveniently? I cut four leaves at a time.

9. Finally, you can cut it into the picture below. Please look at the last step. When all the blades are cut, only strips of plastic are left, but we don't want to waste them. Don't cut yet.

10, the pruning of leaves has started. Please look at the picture below. Can you cut each leaf into heart-shaped or copper-grass-shaped leaves? .

1 1. Trim the first layer, then go to the second and third layers. Finally, we will cut some small holes on the left and right sides of the edge to make serrated leaves.

12. Finally, the following figure can be made, and the branches of each layer of leaves are hierarchically made high and low, so are the leaves.

13. Some flowers that are easy to grow in water can be tried by everyone, and it is also a beautiful scenery at home. Since you can't make a triangular vase, try this method, and this vase is not afraid of wind and rain and is durable. If one day you don't like it, you can throw it away and make a new one.

This is the experience of the assistants of Prodi Particle Counter Division, and I hope to bring some experience to you.