Introduce the making process of a toy.

The process of making bamboo dragonfly toys by hand with foam board;

Tools and materials: foam board, PVC pipe (1/2 inch diameter, about 8 inches long), two 1/4 inch nuts, hot glue gun, tool knife, plastic pipe cutting tool or saw and ruler.

1: Cut out a 2-inch square foam board, place the PVC pipe vertically in the center of the foam board and draw a circle.

2: Cut off the inner part of the ring and pass the PVC pipe through the hole of the foam board.

3: Apply hot glue and slide it upward until it is flush with the PVC pipe end. Cut a small piece of foam board and stick it on it, and coat the bottom seam with hot melt adhesive.

4: As shown in the figure, add 1/4-inch wide foam board at the top.

5: Cut off two propeller blades, each 1.25×8 inches.

6. Glue the propeller blades with hot glue at an inclination angle.

7: Special design of inclination angle can provide upward force after rotation.

The last bamboo dragonfly.