How to knit the Y chair?

The cushion of Y-shaped chair is different from the solid wood panel commonly used in Chinese chairs. It is made of paper rope, and its elasticity and breathability make it extremely comfortable to use. So, how to weave the Y chair? Next, let's take a look at PChouse.

1. First, wrap a 60 cm paper rope around one end of the stick in front of the chair and fix it. Then, wrap a long rope around the other end of the stick from the front leg for 9 times.

2. Turn the long rope that has just been wound for 9 times directly to the upper side of the rear rope winding rod, and then wind it out from the lower side of the rear rope winding rod, and then turn it around and press the rope in front for 90 degrees. Repeat this action, turn 90 degrees, and keep repeating.

3. If you find that there is no place to continue winding the sticks on both sides, but the sticks on the front and back are not completely wound, you can follow the previous method, but you don't need to turn and continue winding up and down. At this time, the Y plate at the back will block the rope winding route, so there will be a long hole on the wooden stick behind the rope winding, and the paper rope at the back will continue to bypass this long hole until it is completely wound.

4. Weave the paper rope to the bottom of the chair surface and fix the end of the paper rope at the bottom. Actually, it was just wrapped around the rope before and then tightened.