Fortune Telling Collection - Ziwei fortune-telling - How to draw graphic design with CAD
How to draw graphic design with CAD
1. Zoom arbitrarily.
The scaling ratio in CAD is proportional to the whole. Can you zoom in on the axis as you zoom in on 3DSMAX? Of course. I do this: first, I choose an object to make a block, and the name of the block is set at will. Such as "33", the insertion point. Usually the lower left point, and then insert the "33" block. On the dialog box, there is a "Scale" column, which can be inserted at any scale.
Step 2 mark the details cleverly
Everyone will set up a labeling system, but when drawing details, what should I do if I zoom in 20 times and ask for 30 times labeling? Of course, a small amount can be made into blocks, but it's not good-looking and it's not easy to change. In fact, the label itself has the option to adjust the scale. Create a new label in the label setting panel, and then click "main company → measuring company size → scale factor". This is the selection scale. Note: the number filled in here is "1÷x", and x is your magnification. In this way, it is marked "X" times smaller than the original, and the details are exactly the original size after being enlarged "X" times.
3. Don't ignore the alignment command
This command is very useful, but not many people know it. "Align" is simplified to "Al". What is its most outstanding benefit? Such as: a square cabinet with an inclined wall. If one side of the cabinet is close to the inclined wall, that is the specialty of this command. Enter the command, select the object (cabinet), specify the first source point → specify the first target point → the second source point → the second target point, and then click OK. The straight lines determined by the two source points and the two target points will coincide.
Skilled in measuring area
The decoration industry should draw up a studio size map and area map and make a quotation. As many people know, the area is usually referred to as "area" or "aa" for short. If it is a Chinese version, select the value "CtrlC" in the graphic model space and then press "CtrlV", so you don't need to fill in one by one. However, the "aa" command has a disadvantage, that is, when there are many endpoints, it is very troublesome, and it is easy to roll over from the command line when counting. If you want to watch it again, you must do it again. Another way is to click "Bo" first, and the picture will be the same as filling, but it is a stroke, and a closed edge will be drawn.
- Previous article:A Dream of Red Mansions Character Relationship Table ()
- Next article:Song Wei Zi's tooth
- Related articles
- Ziweipan divorce
- Is the ancient city of Luoyi and yingtianmen the same place?
- The horoscope of female students on April 2, 20231day.
- When he wants to make Cheng Ju his emperor's home, what constellation does it mean that his Ziquan Palace is occupied by clouds?
- Metaphysical masterpiece
- Lagerstroemia indica; Growing environment; trait
- Sydney Novels after Wei Zi
- Living on the balcony on the first floor, there is no sunshine to grow Chinese roses. Is it useful to use fill light?
- Where is the capital of Shanghai Jinding?
- The fourteenth day of the fifth lunar month