The water output from the shower is getting smaller and smaller. How to maintain it?

This paper introduces some possible reasons and solutions for the decrease of sprinkler water output, so that your sprinkler can restore its original water output. 1. Is the tap water pressure at home lower than before? If yes, you need to find a water company to check the water supply pipeline and pressure.

2. The pipeline valve connected with the water heater is slightly opened: the water inlet valve is opened.

3. Because the living floor is on the high side and the water pressure of the water source is low, the water output is smaller after decompression by the mixing valve. At this time, it is suggested to connect a booster pump in series between the water supply valve and the water inlet of the water heater.

4. The water outlet of the mixing valve is blocked by fine sand and dirt, resulting in a smaller water output. The water mixing valve is inherently insufficient, with a small diameter, and the water output is reduced by throttling: the water inlet end of the water mixing valve can be disassembled, connected to the water supply valve of the water heater by a hose, or directly connected to the hot water outlet end of the water heater by a hose of a shower, so that the water mixing valve can be identified according to the water output of the sprinkler, and the water mixing valve of a regular brand can be replaced on the premise that the water pressure of the water source meets the requirements.

5. Improper installation, rubber ring deformation, uneven or thin outlet pipe joint, mismatch between hose and shower head, etc. Select the appropriate hose and shower head according to the specifications, replace the rubber ring and reinstall it.

6. The nozzle is inherently insufficient, and the internal resistance is large, resulting in small water output: replace the nozzle.

7. The shower hose is broken, the hose is blocked, and the water can't come out: protect the hose during use. Although the crease not only affects the appearance, but also leaks easily due to repeated discount marks.

8. The nozzle is blocked, resulting in poor drainage. Generally, if the water in the home is too alkaline and contains some impurities, it is easy to block the small holes of the shower;

In addition, air sediment and dust will also enter the shower head through the small holes, blocking the shower head for a long time, and improper adjustment of the shower head may also lead to the increase of foreign body scale. We can remove the shower head by rotating and adjusting the shower head, then turn the shower head upwards, find a soft object to knock it gently to shake off the blocked gravel, and clean the shower head one by one, then clean it repeatedly with clear water, and then install it again. Or go to the supermarket to buy a bottle of detergent to remove dirt and remove the shower head. Put it in water and clean it with scale remover. Generally, it will be faster to clean it with warm water. After washing, be sure to scrub the detergent left on the shower head, and then install the shower head as it is. You can also use vinegar (rice vinegar) to soak the shower head in vinegar. Be sure to soak all the holes in vinegar. You can take it out in about ten minutes, then rinse it with clear water to remove the residual vinegar in the shower head, and then you'd better put the shower head back on the shower plate. If the blockage is serious, you can also boil vinegar before soaking, but it should be noted that the use of vinegar is limited to metal showers, and plastic showers should be soaked in cold vinegar. & gt

Besides, if your shower head is fixed on the wall, you can't take it down and soak it in vinegar. You can wrap the nozzle in a plastic bag filled with vinegar, stick it with tape and let it stand for one night, and then remove the vinegar bag the next morning. But be careful not to stick the tape on the circuit board or paint.

At the same time, be careful not to use strong acid when descaling, so as not to corrode the surface of shower head.

The above is the reason for the small water output of shower and the related introduction of the solution for the small water output of shower. I hope it will help you.