How can bricklayers pay off their tiles?

Brick 1 cannot be empty. Knock with your hand. This is a solid brick. The angle should be flat. Touch the splicing angle of the brick, indicating that the brick is very flat. You need to cut the brick and stick it on. You must use the original edge of the brick for collage. If you stick floor tiles, there is also a problem of drainage slope, that is, there is a slight slope on the tile surface, which is conducive to drainage. The wall tiles should be selected before laying and soaked for more than 2 hours to dry the surface moisture. \x0d\2。 Before paving, pay-off positioning and brick arrangement should be carried out. Non-whole bricks should be discharged in secondary parts or internal corners. Each wall should not have two columns of non-integral bricks, and the width of non-integral bricks should not be less than 1/3 of the whole brick. \x0d\3。 Before paving, determine the horizontal and vertical signs, foot pad, and hang up the line before paving. The surface of wall tile should be smooth, the joint should be straight and the joint width should be uniform. The internal corner brick should be pressed to the right, and the external corner line should be docked at a 45 angle. In the protruding part of the wall, the whole brick should be cut and matched, and the non-whole brick should not be used to piece together the shop. \x0d\4。 Mortar should be combined with 6 ~ 10 mm thick cement mortar. The back of the wall brick should be paved with cement mortar, and the top should not be paved with one wall at a time to prevent collapse.