Hairdressing course

The hairdressing tutorial is as follows:

1, shampoo

The first step in a haircut is to wash your hair with warm water, which is easier to take care of. When washing your hair, be careful that the water temperature is not too hot to avoid scalding your scalp, and then massage your scalp with your fingertips.

Step 2 put on work clothes

Wearing a blouse after shampooing can play a protective role and prevent broken hair from falling on clothes during haircut. It is not easy to clean when cleaning. It is best to put a towel around your neck to prevent broken hair from falling into your neck.

3, electric shaver to repair the hair on the ear.

First, shave the ears on the head and the short hair on the back of the head with an electric razor. When holding an electric shaver, be sure to hold your hand tightly, otherwise the shaved hair will be deep and shallow, and uneven, which is very important for beginners.

4. Hair on the top of the head

The next step is to repair the hair on the top of the head. This part of the hair is long and needs to be repaired with fingers.

5. Hold the hair with the middle finger and forefinger, and then cut it with scissors special for hairdressing. Pay attention to whether it is cut flat when cutting, and observe while cutting. Pay attention to the cooperation between your hands.

6, check

At this point, the haircut is coming to an end. All we have to do is observe, comb our hair with a comb, find out the unevenness, and then trim it slightly with a razor to make it smooth.

7. Subsequent partial processing

After finishing, clean up some fine hairs around your neck with a hair dryer at this time.

8. Brush it with a sponge again and take off your blouse.

9. done.