Detailed explanation of shawl knitting teaching course

How to knit a shawl? The answer is as follows:

1, starting, baby pure wool, I used the No.9 needle, starting 20 1 needle. According to the schematic diagram, all needles are divided into three parts, as shown in the figure, 85 needles on both sides and 33 needles in the middle. In the middle is the part where you start to weave flowers.

2. Weave back and forth according to the diagram, and add needles on both sides of the woven part at the same time. Adding needles is to take the required number of needles directly from the guide bars on both sides for knitting. Add 5 stitches for the first time, 4 stitches for the second time, repeat 4 stitches, and weave 1 1 time. Finally, add 2 stitches and repeat knitting 18 times.

This is the beginning of 2-needle back-and-forth knitting and needle addition.

4. Weave a pattern with a length of 4.5cm, and then change it into a smaller horizontal stripe to knit three rows of flat needles (needles on both sides) to close the needles.

5. Hook two rows of short needles according to the required collar size, and finally hook a row of short needle-withdrawing lace to complete the bar needle part.

6. Hook a buttonhole at the last 7 stitches of the second row of short stitches, as shown in the figure.

7. Crocheting part: refers to the hem of the shawl, which is divided into two parts: flower and edge. Flower part: all of them are composed of 22 flowers, each with 10 stitches, 1 1 row.

8. The first row and the second row: all short needles. Hook 22 1 short needle, 199 needle for flower and 1 1 needle for both ends from the front of shawl according to the hood clip diagram, and hook two rows.

9. The third row: the first needle locks vertically, with two short needles, and then (five locked needles, one short needle, five locked needles and three short needles), repeat the hook method in brackets to the last two needles, and hook the short needles.

10, row 4: (tick 5 lock needles and 1 short needle), and repeat the tick method in brackets until there are finally 3 needles left. The hook method of these three stitches is: 2 lock stitches, 1 long stitches.

1 1, line 5: The first needle is the lock needle. (One short needle, one lock needle, then seven long needles, one lock needle, one short needle and five lock needles) Repeat the tick method in brackets until the end of this line.

12, line 6: hook 3 lock needles, (after repeating the hook method in brackets for 7 times, hook a short needle,) repeat the hook method in brackets to the last needle and hook a long needle.

13, row 7: (5 lock needles, hook two short needles and one lock needle at the second and third bead needles respectively, and then hook two short needles at the fourth and fifth bead needles respectively). Repeat this hook method in brackets until there are three stitches left. The hook method of these three stitches is 2 stitches, 1 stitch length.

14, line 8: The first needle locks the vertical needle and two short needles, and then (five locked needles, one short needle, five locked needles and three short needles) repeat the hook method in brackets to the last two needles and hook the short needles.

15, line 9: (tick 5 lock needles and 1 short needle), and repeat the tick method in brackets until there are finally 3 needles left. The hook method of these three stitches is: 2 lock stitches, 1 long stitches.

16, the hook method of the tenth row is the same as that of the fifth row, except that the seven long needles should be changed to eight long needles.

17, the tick method of the eleventh row is the same as that of the sixth row, except that the seven beads are changed to eight beads.

18, starting from the first row of short stitches, hook 16 short stitches at one end of the shawl hem, and then (3 stitches, 1 short stitches) repeat the bracket method until the flower ends. Hook the stitch of 16 on the other end of the hem, and the shawl is completed in this step.

The above is the knitting method of thick wool shawl, I hope it can help you for a while.