How to turn on and off the lights?

In the use of motor vehicles, there are two ways to control the lights. Among them, it is mainly divided into knob type and lever type, and the use methods are different when switching in different ways.

1 and 1 modes are knob control switches, and the knob of the knob control switch needs to be placed on the light file that needs to be opened clockwise. The operation method of the knob control switch is simple, and the lamp can be turned on normally after being turned on. When closing, you can turn the knob in the opposite direction to the closed position.

2. The second mode is that the control switch is in lever mode. Turn on the lever control switch, and there will be signs such as high beam, low beam and fog light on the lever position. When in use, just pull the control lever to turn on the corresponding light. Lever control can turn off the lights like the driving side.

Some motor vehicles are equipped with the function of automatic headlights. The function of automatic headlamp requires that the light controller of motor vehicle be placed on the automatic control switch. At this time, the light sensor of the motor vehicle can sense the external light, and the headlights of the motor vehicle can be controlled to be turned on or off through the external brightness.

In this case, the driver of the motor vehicle does not need to manually control the switch of the headlight of the vehicle, which is simpler and more convenient to use and can increase the driving safety of the vehicle.

When the lights of motor vehicles are used in different places, there are different lighting requirements. Motor vehicles mainly include high beam, low beam and width indicator. The high beam is generally used in dark places or when there is no vehicle in the opposite lane, while the low beam is generally used in dark sections of normal driving, and the width indicator is the driving light of motor vehicles.

Matters needing attention in the use of automobile lighting:

1. Drive the low beam at night.

2. When the rear vehicle driving in the same direction is close to the front vehicle, the high beam shall not be used.

3. When passing through sharp bends, slopes, arch bridges, crosswalks or intersections without traffic light control at night, you should alternately use far and near lights to signal.