How to make toys

Materials and tools: cardboard, straws, balloons, hot melt glue gun, bottle caps, sticks, adhesive tapes, scissors, pen knives.

1. Make a car shape with cardboard.

2. Then dig two holes in the bottle cap with a pen knife, insert two straws and fix them with hot melt adhesive.

Put the bottle cap on the top hole of the car.

4. Make car wheels with straws, sticks and bottle caps.

5. Put the balloon on the bottle cap and fix it with adhesive tape, and the car will be finished.

Second,

Materials: prepare cardboard, coins, scissors, pencils, double-sided tape and toothpicks.

1, first draw the gyro shape on the cardboard with a pencil, like the fan blade of an electric fan, and cut the drawn gyro with scissors.

2. Stick double-sided tape on the ends of the three sectors, and stick coins on the double-sided tape.

3. Stick all three coins on the sector with double-sided tape. The heavier each page, the faster the rotation speed.

4. Cut two circles the size of coins from the cardboard with scissors.

5. Stick the two circles on the center of the front and back of the gyro with double-sided tape.

6. Pass the toothpick through the center of the gyro, and cut both ends of the toothpick short with scissors, leaving one centimeter on each side.

Third,

Cardboard plane:

1, first prepare a piece of cardboard, as shown in the following figure:

2. Cut the cardboard into the following figure and divide it into three equal parts according to the lines drawn on the cardboard, as shown in the following figure:

3. Draw a knife along the paper with a knife. If it is a single-layer cardboard, just fold it against the line, as shown below:

4. Then dig four long holes and cut off two oblique angles of the nose, as shown in the figure below:

5. Then cut off the front and rear wings and tail, as shown in the figure below:

6. Then insert the wings into the rectangular holes, as shown in the following figure:

7. Stick the opening on it with a seal.