Rabbit bracelet weaving tutorial

Tutu tutu bracelet weaving tutorial is as follows:

1. The green thread begins to weave. First, six stitches. Then, it went back to the second floor and began to lock needles in each pinhole, counting five needles. Then, it locks six layers in the same way, with five stitches on each layer.

2. The first pinhole locks 2 stitches, then 3 stitches, and the last pinhole locks 2 stitches, counting 7 stitches, which is the first layer. Then on the second floor, each pinhole lock 1 pin counts as 7 pins. * * * Locking needle 14 layer, with 7 needles per layer.

3. Lock the first pinhole and the second pinhole into 1 needle, then lock 3 needles, and finally lock the second needle and the last needle into 1 needle to complete a layer, counting 5 needles, and counting 6 needles, with 5 needles in each layer.

4. Then overlap the two ends and lock them along the contour line. When they reach the middle, add filling cotton and continue to lock the needle 1 turn. The rabbit's body is basically finished. The rabbit is finished.

5. Draw 7 stitches, and then go back to the fifth stitch to draw a pinhole. The long needle distance in the hook is 5 needles, and it is locked into the second needle hole of the initial needle hole of wire drawing. Pull the needle 7 times again, then return to the single needle at the fifth needle, hook the long needle 5 times and lock it in the second needle of the initial needle. The rabbit's ears are ready.

6. Lock the needle 7 in the middle of the body, lock the long needle 3 in the hook to the center, then jump to the other side of the body and continue to lock the long needle 3 in the hook to the center, and the needle will be broken. Sew the eyes and mouth with black thread, and the lovely rabbit is finished.