How to make a paper vase

How to make a paper vase! About 10cm! Then stick the strips together ~ ~ and when it is dry, cut the paper mold wrapped outside the vase with a knife, and it will be half, still hard. Then paint it the way you like, the color! The most important thing: after painting, stick two and a half vase molds together! Finally, what kind of glue (hey hey, what kind of glue is it? I forgot! Excuse me! _) Ready! (1) Blow up the balloon, tie it tightly and tie a knot. A balloon can only make one vase at a time. (2) Tear the newspaper into pieces, put the pieces into a juicer or food processor, add some water, then start the switch, and continue to add paper and water until no paper can be seen. Whether it's successful or not, try it with your hands. If it's slippery, it means you did the right thing. This is pulp. After completion, pour the finished slurry into the sink, add the glue, and stir carefully by hand. (3) Gently wipe our stirred pulp on the blown balloon, paying attention to leaving a bottle mouth, and then take it to the sun to dry. (4) When the pulp outside the balloon is completely dried, beautify the vase with pigments. Finally, let the air out of the balloon. The flesh outside the balloon is dry. Let's finish the last step. You can make a vase with a little trimming!

How to make an origami vase 1 The hardest thing to start is the first lap. After the first lap, you can fix it with a rope, and then add a second layer.

When closing the door, be careful to insert it backwards and throw one in each lap.

It is best to choose soft glue such as white latex as glue. Ordinary glue will harden after drying and deform when pressed.

Generally, the first floor starts with 54 sheets, and each floor is increased by one sheet, and each floor is decreased by one sheet, which is about 15 pairs.

Practice makes true knowledge, and hands-on results. Try it a few times by yourself.

:jingyan . Baidu ./article/f 7 1d 603743 174 f 1ab 64 1d 1a 9。

:zhidiy。 /zhezhirumen/2 158/

Is this ok?

There are two ways to make vases with raw rice paper, one is the ordinary method, and the other is the simple method.

First, the required materials:

Vase mold, white latex, clear water, raw rice paper (old newspaper is also acceptable), brush, water container (basin or small bucket), wallpaper knife (art knife), putty powder, No.0 water sandpaper, colored pigment, etc.

Second, the steps:

Step 1: Choose a favorite vase (preferably porcelain) and use it as a mold after washing the appearance with clear water;

Step 2: Cut raw rice paper or old newspaper into paper strips with a width of 2-5cm and a length of 15-30cm, and the specific size can be adjusted according to the size of the vase;

Step 3: the container is filled with water, and a small amount of white latex is added as an adhesive;

Step 4: Soak the previously cut paper strips in water, and then use them (soak them for more than one time and take them out one by one).

Step 5: spread the soaked paper strips on the bottle, gently roll out the air between the paper strips and the bottle by hand, try not to generate bubbles, the directions of the sticker strips should be different, and the paper strips can overlap each other, so as to make the final product more firm;

Step 6: Stick strips on the bottle continuously until the bottle is completely wrapped. Pay attention to the thickness of the paste bar to be uniform, neither thin nor thick;

Step 7: dry it slightly, and then repeat steps 4-6 until the thickness of the note reaches your satisfaction;

Step 8: put the bottle in a cool place to dry, avoiding exposure and high temperature baking;

Step 9: after the wrapped paper strip is completely dried, cut one side of the bottle body with a utility knife, take out the mold, and stick the cut firmly; (Friends with strong hands-on ability can put this step before step 6. )

Step 10: Mix the putty powder, completely cover the outside of the paper bottle, and smooth it with sandpaper;

Step 1 1: Draw your favorite colors and patterns with pigments;

Step 12: Now you can show off your work to your friends!

Third, the summary method

Another simple method is to prepare an inflatable balloon, blow it up, seal its mouth and use it as a mold. Other steps are carried out as usual. After the paper strip is dried, the balloon can be taken out after deflation. Using balloons as molds, toys, helmets, masks, lampshades and other small productions can be made.

How to make paper flowers