Weaving method of pure red rope bracelet

The red rope bracelet is woven as follows:

Material preparation: red rope.

Operating steps:

1, make a double connection first.

2. Put three red ropes between the two red ropes at the bottom of the duplex and tie a knot after putting them away.

3. Then put the hung red rope in the picture.

4. Take out two double red ropes.

5. Then take the top two red ropes and cross them on the main rope in the middle at a time, and so on.

6. If it is woven into a suitable length, you can use the remaining two red ropes to make a double connection; Our red string bracelet is finished.

Second, the second method

1 First, prepare the required materials. We need a red rope about 160cm, or we can add some small pendants ourselves, depending on our choice.

Then we start knitting, fold the thread in half and tie the first knot as a start.

Leave a buttonhole at the top, and then you can start to tie the diamond knot. The rope winding method of diamond knot is very simple.

4. The method according to the above steps has been compiled, and it has been compiled to half of the total length. You can choose to wear accessories or continue to compile.

When the whole length of the bracelet is almost woven, we start to tie the knot, and the buttonholes left in front can be buckled together. The knitting method of the knot is shown in the figure. Arrange the threads first, then thread the lower thread through the double ring, then thread another thread through the same ring, and then gently tie the knot and tighten it, and the knot is finished.

6. Then cut off the excess red rope and burn the tail line with a lighter, and the diamond knot bracelet will be finished.