How to explain the method of DIY crystal painting

The raw materials are: No.6 nylon yarn and acrylic (or crystal) beads. If your hand is hurt by the thread, you'd better prepare a pair of gloves.

Step one.

Starting from the bottom, cut a section of 6 # nylon thread, which can be 4 meters (the novice can be shorter). See the next picture, put four beads in the middle of the line, that is, keep the length of the left and right lines about 2 meters.

Step two.

Grab the line with your left hand. Grasp the thread with your right hand and wrap it around the front (from right to left) from the back of your left hand. After winding, put it back on the last bead of the original right hand (from right to left). After threading, tighten it with both hands (note: the contact point of the two wires should be pulled to the center of the inner hole of the bead to make the bead firmly fixed).

Step three.

Just be the first flower. See 3. Tall buildings have sprung up, and the whole box is made up of many flowers. Therefore, Qianshan is full of hardships, wonderful and beautiful.

Step four.

Next, wear one on your left hand and two on your right.

Step five.

The right hand thread goes from the back of the left hand thread to the front (from right to left), and then returns to the last bead on the original right hand side (note: 1.

Wear the last of the two beads on the right hand side, not the previous one, and the direction is from right to left;

2。

The beads on the left hand should be below the intersection of the two lines. The operation of threading beads by hand is the same as the next step, except that the number of beads is changed.

Step six.

So the next flower was born. Look at the following paragraph.

Step seven.

The next process is the same as the fourth and fifth steps. Put the beads on first, then put them back and tighten them, and so on, so that you can wear ten groups of small flowers (so that the vertical edge at the bottom comes out).

Step eight.

After putting on the tenth group, it will bend at this time. No beads on the left hand, three beads on the right hand. The action is the same as the second and fifth steps. After the right hand paper bypasses the left hand, the last of the three beads in the right hand is obtained.

Put it on and tighten it.

Step nine.

After turning the corner, the practice is still the same as the fourth and fifth steps. Wear one on the left hand and two on the right hand, and put on the back reference film.

Step 10.

Next, through four groups by analogy. After wearing it (so that the horizontal edge at the bottom comes out), it will turn. The rotation operation is the same as the eighth step, without beads in the left hand and three pills in the right hand. After wearing, refer to film 9.

Step eleven.

Then, continue to wear another vertical edge at the bottom in the same way as in the previous steps 4 to 7. Turn it after wearing it, and the method of turning it is the same as the eighth step.

After turning the corner, continue to make another horizontal edge.

The method of horizontal edge is the same as steps 9 to 10.

(Summary: The vertical and horizontal sides in this step are the same as the other two sides. )

Step twelve.

It's done on all sides. Prepare the connector, as shown in figure 10. The left hand thread passes through the top bead on the vertical side, and the right hand thread passes through two beads. Then the threading method is the same as step 5. After wearing it, tighten your hands so that the first layer at the bottom will be fine.