How to adjust the time of Omega constellation series?

In normal walking mode, press and hold the upper left corner to enter the time setting. Please refer to the attached manual for details.

1: Pull out the crown, stop all hands of the watch and enter the state of "adjusting time". Adjust the time to six o'clock sharp at this time. This is done to avoid damaging the date module when adjusting the date after one week.

2. Push the crown back to "Adjust Date and Week" status. At this point, the hands of the watch start to turn normally and can be ignored.

3: The day before the date and watch adjustment. For example, today is Friday the 29th. If you adjust your watch now, adjust the week to Thursday and the date to the 28th.

4. Pull out the crown again to the state of "adjusting time" when the pointer stops, start to adjust the time, let the pointer rotate clockwise, adjust the time until the pointer indicates that it is close to 12, and jump to the next day when the date and week are found. This jump may not happen until the pointer passes 12 for the second time.

The pointer of the date jump description table now shows that you set your watch at this time of the morning. If you happen to set your watch in the morning, adjust it to the current accurate time and then push the crown back completely. The pointer rotates normally, and the adjustment of the watch is over.

6. If you set your watch in the afternoon, continue to adjust the time and let the hour hand pass 12 again. At this time, the watch will indicate the afternoon time of the day when you adjust the watch. At this time, you continue to adjust the watch time to the current accurate time, push the crown back completely, the hands will rotate normally, and the watch adjustment is over.

In normal timing mode, press and hold the lower right corner, and the upper liquid crystal displays H-SET, and the lower liquid crystal flashes sub. Press the bottom left again, and the lower liquid crystal will become 0: 00. Then press the lower right to adjust the pointer to the position of 12: 00, and then press the upper left, and the pointer will be automatically adjusted to be consistent with the LCD.