Manual beaded dog tutorial

The manual beaded dog tutorial is as follows:

1. Prepare a long enough elastic thread and fold it into two strands. Double-stranded wires must be used here. Single wire has many shortcomings and is very easy to break.

2. Thread the beads together with steel wire. It should be noted here that some beads have a head and a tail, such as a round olive core. Be sure to look good before wearing it.

3. Put one of the two single wires through the other end.

4. String the intersection of two lines to other positions, because it will be knotted later to avoid knotting and intersection.

Tie two knots on two single lines, but if your bracelet has a thick hole, you can tie three knots if you don't trust, which is safer.

6. Cut off the excess thread, leaving about 0.5 cm of thread.

7. Hide the knot in a bead so that you can wear a beautiful bracelet.

Beaded introduction:

Beaded beads, also known as "jumping beads", as the name implies, are beads made of crystal, wood, agate, glass, amber and other textures, and DIY creates your beloved jewelry. In recent years, it has gradually developed into a large category of handmade ornaments, and children, young people, middle-aged people and the elderly have begun to make them. Beaded beads have become one of the most eye-catching fashion and entrepreneurial shortcuts.

Maintenance method: rubbing the bead surface with a bath towel is actually to clean the wax layer and dirty color on the bead surface and re-polish it, depending on the specific situation.

Polishing with a soft cotton cloth for a week is also considered polishing. At this time, there will be red marks on the surface of the soft cloth, which is a normal phenomenon, and the color will fade after one week. Let it stand for a week, let the beads dry naturally, and at the same time contact with air to form a fine and uniform oxide protective layer.