The process of knitting bracelets with rubber bands is simple.

The tutorial for weaving bracelets with rubber bands is as follows:

Material preparation: rubber band, plastic fork.

Operating steps:

1, open the rubber band, take out all tools, and then put the rubber band on the plastic fork in parallel, three rubber bands at a time.

2. Hook one end of the bottom rubber band from the plastic fork with a plastic crochet needle, then hook the middle of the bottom rubber band with one end of the plastic splayed hook, then hook the other end and tighten it evenly. There are only two rubber bands on the plastic fork at this time.

3. Then add a rubber band to the plastic fork.

4. Hook the rubber band below in the same way and tighten it evenly. There are only two rubber bands on the plastic fork at this time.

5. Add another rubber band and hook it down in the same way. Just add the rubber band again and again, hook it down again and again, and tighten it slowly. Just edit it to your own length.

6. After editing to the length in your mind, start closing your head. When closing your head, don't add a rubber band until you receive the last rubber band.

7. When the last rubber band is connected, hook one end of the plastic hook that started to hook, first hook one end of the last rubber band on the plastic fork (as shown in figure 1), and pull out the plastic fork at that end.

8. Hook the other end of the rubber band with a plastic hook and pull out the plastic fork. Slowly arrange the rubber band, double fancy

The rubber band bracelet is finished.