How to make a girlfriend bracelet

Prepare tools/materials: thread, scissors, lighter.

Step 1: Prepare 6 threads and tie a knot. ?

Step 2: Pick up two threads on both sides, wrap them around the four threads in the middle, and tie a neat knot with one of the two threads as the starting thread.

Step 3: After tightening slightly, tie the knot from the other side.

Step 4: Tie the knot five times in this left-right order.

Step 5: After that, tilt the last one downward, then tie all the wires around this wire, and punch each wire twice in succession.

Step six, turn this line in the opposite direction and make an angle of about 90 degrees. Keep tying the knot on this line.

Step 7, continue knitting in this order until it fits the length of your wrist. ?

Step 8: While waiting for finishing, repeat steps 3 and 4, and tie five arranged knots to tighten.

Step 9: After knotting, tie several threads together symmetrically.

Step 10: Cut a short piece of string again, pull both ends of the bracelet up like the middle, neatly, and continue to tie a few neat knots.

Step 11: Weave to the right length, cut both sides short and leave a small part. ?

Step 12: Burn both sides with a lighter and put them on immediately.

Step 13: After a little tidying up, a beautiful bracelet is finished.