How to use leaves as bookmarks?

Method 1: You can pick some maple leaves or ginkgo orchards. As long as they look good, you can stick tape on the leaves and then draw a small circle on the leaves with a knife. Not too big. Be careful when using a knife! ! ! Finally, tie your favorite rope and have some fun. 2. The transparency steps are as follows: 1. Pick up the leaves. 2. Put the leaves and alkali together and cook for a while. 3. After the leaves are cooked, take them out and gently scrape off the green on the surface with a fine-haired toothbrush. There is only one transparent leaf left. 5. Finally, put it in a ventilated place (no sunlight) to dry. Method 3: Choose leaves with clear and smooth veins and soak them in clear water for a few days until the "meat" on the leaves can be removed by hand, then wash them with water and spread them out on the book.

How to make leaf bookmarks is very simple.

If you don't want to break it easily, you must follow the steps, such as alkali blocks, leaves and fine bristle toothbrushes. The above method is relatively simple. 1. Pick up the leaves. 2. Cook the leaves and alkali together for a while. 3. After the leaves are cooked, take them out and gently scrape off the green on the surface with a fine-haired toothbrush. There is only one transparent leaf left. 5. Finally, put them in a ventilated place. Inside the epidermis are some mesophyll tissues containing green leaves, which can be used for photosynthesis. Through mesophyll tissue are veins composed of transport tissue and mechanical tissue. Veins bookmarks is made of veins only by removing epidermis and mesophyll tissue. On the bookmark, you can see that a thick vein in the middle is called the main vein, and many smaller branches on the main vein are called lateral veins; On the lateral vein, there are smaller branches called veinlets. In this way, the whole venous system is finally connected into a network structure. Dye the mesh in various colors, tie a ribbon and make a beautiful mesh bookmark. Now let's talk about the whole process of making veins bookmarks: leaves from cortex are usually used, such as leaves from osmanthus trees and leaves from beech plants. The picked leaves should be the right size, not incomplete, older and not too tender. After picking leaves, put them into a beaker (as shown in Figure 1), add 10 ~ 15% sodium hydroxide aqueous solution (until the leaves are submerged), heat and boil 10 ~ 15 minutes (as shown in Figure 2), take them out and spread them on plastic gauze. After the above treatment, the epidermis and mesophyll tissue of the leaves are dispersed and washed away by tap water, leaving reticular veins. After washing the veins, pick them up and spread them on absorbent paper, press them dry and flatten them, and then dye them in the dye vat. A variety of dyes can be used for dyeing (as shown in Figure 4). Red ink and blue ink are also good. Dye 1 ~ 2 hours, take it out, spread it flat on absorbent paper, flatten it and dry it. After taking it out, tie a ribbon at the bottom of the coarse texture to make a texture bookmark.

How to make veins bookmarks and vein crafts with leaves

Veins bookmarks is a bookmark made by selecting beautiful leaves, removing mesophyll by chemical treatment, keeping intact veins and dyeing.

Production method:

1, select the blade. Choose leaves with thick veins. Generally evergreen woody plants are better. Such as osmanthus leaves, heather leaves, papaya leaves, eucalyptus branches and leaves, tea and so on. Choose leaves in late summer or autumn when they are fully mature and begin to age.

2. Boil the leaves with lye. Alkaline solution configuration: based on 1 liter of water, sodium carbonate (baking soda) 70g, sodium hydroxide 50g (the above two drugs and chemicals are available in stores), or lime water is used instead of alkali solution. Boil the prepared lye in an enamel cup or casserole, then put it in a proper amount of washed leaves, and gently stir the leaves with chopsticks to prevent the leaves from overlapping and heat them evenly. Cook for about 5 minutes. After the leaves turn black, take a leaf and put it in a plastic basin filled with clear water. Check the corrosion and easy peeling of mesophyll. If it is easy to separate, take all the leaves out and put them in a plastic basin filled with clear water, and then separate the mesophyll and veins one by one.

3. Remove the mesophyll. Put the cooked leaves on the palm of your hand or a glass plate, gently rub them with the smooth part of the old toothbrush handle to wipe off the corroded mesophyll, then rinse them under the tap and continue rubbing until the mesophyll is completely removed.

4. Bleach blood vessels. Bleaching the scrubbed veins in bleaching powder solution, taking them out, washing them with clear water, putting them into old books and newspapers, absorbing moisture, and taking them out as veins bookmarks.

5. Dye, draw and write. Dye your favorite color with red and blue ink or other dyes, or draw and write on it, and finally tie it with silk thread.

How to use leaves as bookmarks? ask

1. Pick up the leaves.

2. Boil the leaves with alkali for a while. 3. After the leaves are cooked, take them out and gently scrape off the green on the surface with a fine-haired toothbrush.

This leaves only a transparent leaf.

5. Finally, put it in a ventilated place (no sunlight) to dry. It's Baidu's ~ but I usually pick up fallen leaves and put them directly in the book ~ it's also a nice faint taste and the color of life.

How to make bookmarks quickly with leaves

First, put the leaves in a thick book (the thicker the better). Almost a week later, it was dry. At this time, hunger is very fragile. You should carefully stick it on the paper, cut it along the edge, make a hole, tie a rope and draw some patterns. It's made! That's what I did!

Give some points and fight by yourself! ! ! !

When finished, you can put it in the book again.

How to make a bookmark for leaves

Method for make texture bookmark

1, select the blade. Choose leaves with thick veins. Generally evergreen woody plants are better. Ru Gui

Mosaic, heather leaves, papaya leaves, eucalyptus leaves, tea leaves, etc. At the end of summer, when the leaves are fully mature and begin to age.

Or choose leaves in autumn.

2. Boil the leaves with lye. Configuration of lye: calculated by 1 liter of water, 70g of sodium carbonate (baking soda) and hydroxyl oxide.

50 grams of sodium chloride (the above two drugs and chemicals are available in stores), and lime water can also be used as an enamel cup instead of lye or

Boil the prepared lye in a casserole, then add some washed leaves, boil and gently stir the leaves with chopsticks.

, to prevent the blade from being compressed, so that it is heated evenly. Cook for about 5 minutes. When the leaves turn black, take out a leaf.

Son, put it in a plastic basin filled with clear water. Check the corrosion and easy peeling of mesophyll, and remove it if it is easy to separate.

Take out all the leaves, put them in a plastic basin filled with clear water, and then separate the mesophyll from the veins one by one.

3. Remove the mesophyll. Put the boiled leaves on the palm of your hand or a glass plate and smooth them with an old toothbrush handle.

Gently rub the leaves to wipe off the corroded mesophyll, then rinse under the faucet and continue rubbing.

Until the mesophyll is completely removed.

4. Bleach blood vessels. Bleaching the brushed veins in bleaching powder solution, taking them out and washing them with clear water.

Sandwiched in old books and newspapers, it can be taken out after draining, and it can be used as a veins bookmarks.

5. Dye, draw and write. Dye your favorite color with red and blue ink or other dyes, or draw and write on it, and finally tie it with silk thread.

But it's complicated and requires a lot of materials. That's what I did.

Leaf bookmark, simple method,, (home),

Pick a leaf you like, which is relatively flat, put it at home, wipe it clean, put it in the page, open it every day, and wait for it to dry slowly without any change. When it's dry, it's a little brittle. Handle with care, you can use plastic film for plastic packaging.

How to make a "leaf bookmark"

First post a picture of my finished product: (this is the night scene) 100% pure natural handmade! There are many bookmarks on the market, but I hardly see anyone selling leaf bookmarks. It may be that the production process is too complicated, the labor cost is high, the market demand is small, and it is not cost-effective. It is also possible that too few people know how to do it. But it doesn't matter, now my production method tells you that you can also easily make a unique bookmark of leaves and meridians, which is a good thing for giving gifts and making friends at home! In fact, this method is not my original creation. I still remember that the political teacher in junior high school once told us how to make two leaf bookmarks when rewarding students. But then I did it three times and improved a lot on the original method. Let's briefly summarize it first. In fact, the method is very simple and unique. Required materials: magnolia leaves, water (yes! Tap water will do! ), basin or bucket. Time-consuming: ten to twenty days. If you don't count the time, you are looking for magnolia leaves. ) process: 1. Wash the selected magnolia leaves and put them into a basin (or bucket); 2. Fill the basin (or bucket) with water, at least cover the leaves; 3. It will take about ten days to wait for the leaves to rot; 4. After the mesophyll rots, take out the leaves and gently scrape the mesophyll with your fingers (or a soft brush); 5. Rinse the leaves with clear water and then hang them (or press them with paper) to dry; 6, DIY leaves meridian bookmarks produced! Of course, this is just a rough process. There are still many details to pay attention to in actual operation. If these details are not handled well, it is very likely that all the previous efforts will be in vain, or you will suffer (this, I will explain below). First, the choice of leaves. Magnolia leaves are the first choice. This is the magnolia tree: there are many common trees, but not every tree's leaves can be made into the meridian bookmark shown in the opening picture, at least not by my pure natural method. But it is said that it should be possible to use some chemicals, such as sodium hydroxide or formaldehyde, but I have never tried this method. Magnolia trees are always common in the south. On both sides of this road are: Generally speaking, the leaves of magnolia trees are the best. I made this bookmark for the first time in junior high school. I am at the age when I like to question things around me, so I don't believe that only magnolia leaves can be used. Then I chose many other kinds of leaves to do experiments together, such as Ficus macrophylla leaves, kapok leaves, canna leaves, banana leaves (I really chose banana leaves, but the smallest ones) and some I forgot. In short, I picked out all the leaves that I could see around me, and tried everything that had something in common with magnolia leaves. As a result, magnolia leaves were soaked in water for more than ten days. Magnolia Ye Quan soaked the leaves, and the other leaves were all green, as if they had just been put in. At this point, after personal experience, I am willing to give up and have no hope for other leaves. But after all, I have tried the common leaves in the south, and I don't know if the leaves of other varieties in the north will do. If my friends in the north are diligent and curious, they might as well try it for me, which will also make me completely give up. In addition, it should be noted that not all leaves can be collected by this simple method, and not all magnolia leaves can be collected.

How to Make Bookmarks with Leaves 100 Integral

1. Pick up the leaves.

2. Boil the leaves with alkali for a while.

3. After the leaves are cooked, take them out and gently scrape off the green on the surface with a fine-haired toothbrush.

This leaves only a transparent leaf.

Finally, put it in a ventilated place (no sunlight) to dry.

How to make veins bookmarks and vein crafts with leaves

After cleaning the leaves, cook them with alkali liquor (70g baking soda, namely sodium carbonate, or 50g sodium hydroxide).