How to weave a bracelet with a small rubber band

How to weave bracelets with small rubber bands is introduced as follows:

1. The required materials, tools and steps are as follows. The simple version of the tool is your own hand, and the material is colored rubber bands and small hooks for finishing. The tool version is organized with special tools that look like slingshots, crochets, colored rubber bands and small hooks. The steps of special tools with tool version are relatively simple.

Second, wrap two figures of eight around the tool. Turn the two ends of the lower eight characters up and put them in the middle of the upper eight characters, not the bracket. Put the small hook for finishing on the rubber band turned up below and use it when finishing. Cover 8 on the tool with a rubber band.

3. At this time, turn both ends of the figure-eight rubber band in the lower layer onto the figure-eight rubber band in the upper layer, remove the tools and put them in the middle of the figure-eight rubber band in the upper layer. Repeat this step until it is long enough. Hook the last 8-shaped rubber band from the tool with a crochet needle and put it on the crochet needle. Hang the last layer of rubber band on one end of the small hook and arrange it with crochet.

4. If there is no special tool, hang the small hook for trimming on the rubber band. Put another rubber band on the first rubber band. Continue to put it down until it is long enough. Pick out the part between the first rubber band and the second rubber band and hang it on the small hook. At the same time, put the folded end of a rubber band at the end of the hook, and it is finished.