12 Constellation Manual Dressing Doll Machine _ Twelve Constellations Dressing Paper Dolls

The operation method of manual doll machine is as follows:

Tools and materials: some cardboard, 8 syringes, 4 hoses, some ice cream sticks, hot melt adhesive, hot melt glue gun, toothpicks, pencils, rulers, transparent plastic paper, pigments, dolls, electric drills, scissors and art knives.

1, cut out a piece of cardboard with a length and width of 40cmX30cm (used to grab the top of the doll machine, which can be cut according to your own preferences).

2. Take out a hole 10cm square at the top, which is mainly for putting dolls, and cut according to the size of dolls.

3. Cut two pieces of cardboard with a length of 30cmX3cm and stick them on both sides with hot melt adhesive. Dig two grooves about 1cm deep on the corresponding sides.

4. Put the PVC pipe into the card slot. Note that two pipes should be sleeved with a thick pipe, about 10cm, which can slide freely.

5. Align the thick pipes outside, coat them with hot melt adhesive, and stick a wooden board with the length and width of 30cm× 10cm.

6. Prepare a number of wide ice cream sticks, punch holes in the middle and both ends, with three eyes in total, and pay attention to equidistant.

7. When assembling, prepare two and a half ice cream sticks and fix them with toothpicks.

8. The following links are closed in turn, superimposed left and right, and all fixed with toothpicks.

9. Put Xiao Mu washers on both ends, and then drop glue to prevent the clips from coming apart. When the glue dries, cut off the extra toothpicks. Be careful not to cut the toothpick at the top of the picture below.

10, punch holes on the edge of the syringe and the handle of the syringe, and fix them on the telescopic arm.

1 1. Apply hot melt adhesive to one of the card slots at the top of the doll machine, stick a piece of cardboard as a medium, and then apply hot melt adhesive to the cardboard and stick it to the needle cylinder.

12. Install as shown below, and insert uncut toothpicks into the cardboard.

13. Stick two layers of cardboard as shown in the figure to fix the telescopic arm.

14. Set two more PVC pipes in the vertical direction in the same way as before.

15. Make another telescopic arm according to the previous method and fix it.

16. A mechanical arm is bonded vertically, and the small cardboard on the left is used as the gasket for bonding the syringe.

17. Cut three identical parts as shown in the figure, and draw some holes.

18, as shown in the figure, is linked by a needle cylinder through a wire. Pulling the needle cylinder can control the opening and closing of the mechanical claw.

19. Cut out the cardboard with the same size as the top of the doll machine, with a length and width of about 40cmX30cm. Cut out a rectangle in the upper corner, the size is according to your own needs, and this is the exit of the doll.