How to make the National Day bracelet?

The manufacturing steps of the National Day bracelet are as follows:

First draw a heart and a five-pointed star with a piece of yellow cardboard, and cut it out for later use.

Step 2: Cut a piece of red cardboard into long strips, measure the hand circumference, draw the hand circumference length in the middle with a ruler, and draw half hearts at both ends.

Step 3: Cut off, cut half of the openings at both ends, cross-buckle, and paste the prepared five-pointed star.

Seven basic cutting methods of paper-cutting;

1, symmetrical folding cropping method: fold in half, draw half of the image and crop it.

2. Triangle folding and cutting method: Fold the square paper in half, fold it 60 degrees as shown in the figure, and cut it.

3. Quadrilateral folding and cutting method: fold it in half twice, then fold it diagonally, draw a half pattern and cut it. But when designing, we must pay attention to the connection points on the left and right sides, otherwise it will be cut into pieces. Use square colored paper, fold it in half three times according to the figure, fold it into a triangle, and then cut out various patterns according to the rules of four corners, four sides and center.

4. Pentagonal folding and shearing method: fold the square paper in half, and then fold it according to the midpoint of the triangle bottom.

5. Hexagon folding cutting method: Fold the square in half, and then fold it into a figure according to the midpoint of the bottom edge and the dotted line in the figure.

6. Cutting method of flower cluster: A single pattern (1/4, 1/5, 1/6, 1/8 of flower cluster) is designed by folding methods such as quadrangle, pentagon and hexagon, and a symmetrical flower cluster is formed after unfolding. When designing, it is necessary to highlight the directional continuous movement characteristics of lace and form vivid charm. Cut the details first, then the thick part, first inside and then outside, and the thin part can be carved with a knife.

7. Cutting method of corner pattern: corner pattern is also called corner flower, which is often based on a 90-degree right angle. After diagonal folding, design a corner pattern, cut and spread it to decorate the corner pattern. If the corner pattern is connected, it becomes a border pattern.