Hand-carved origami method

Preparation materials: 5 pieces of 7.5cm*7.5cm square origami (red 3 green 2), glue stick, scissors, black pen and toothpick.

Rose origami course:

1. Take a red 7.5cm*7.5cm square origami and fold it up and down, then fold it left and right.

2. Fold it in half along the diagonal line connecting the two ends of the open end and the closed end, then draw an arc on it with a black pen, then cut it along the mark with scissors, cut a small hole at the top corner (be careful not to cut it too big), and finally spread the paper completely. Fold two identical petals, a total of three.

3. Take a folded petal, cut off one petal with scissors, then take the second petal, cut off two petals, take the third petal and cut off three petals. As shown in the figure.

4. Apply a glue stick to three or more petals, and then curl each petal with a toothpick.

5. Take a green 7.5cm*7.5cm square origami, roll it into a cylinder, and fix the end with a glue stick to get the flower stalk.

6. Draw a cut petal with a glue stick and paste it at one end of the flower stalk, then draw two cut petals with a glue stick and paste them on it, and then fix the remaining petals at one end of the flower stalk in the order from small to large (note that if the holes cut by the petals are too large, they can be fixed with a glue stick); At this time, the flower part of the rose is completed.

7. Take a green 7.5cm*7.5cm square origami, fold it up and down, and then fold it left and right.

8. Draw the shape of the leaf at the crease with a black pen, and then cut it along the mark with scissors.

9. Apply a glue stick to one end of the leaf and stick it on the flower stalk; At this moment, a beautiful rose broke.