Turn waste into treasure, and make a small collection by hand (hanging)

Don't use infusion tubes to make handmade goldfish.

Specific steps:

1

Cut two sections of 10 cm long pipes, circle them with scissors and cut them into patterns to make tails.

2

Prepare a square bead for your eyes, preferably red. If not, you can directly use the speed control button of the infusion tube to cut off the thick tube of the speed control button and make a hook for the goldfish to hang on the key.

three

Cut two sections of circular tubes about 15cm long for use.

four

Break most of the remaining pipes.

five

Cross the two round tubes and clamp the tail.

six

As shown in the figure, wrap the cut pipe left and right.

seven

When winding in half, wrap both sides of a circular tube in half, as shown in the figure.

eight

Cross the remaining two round pipes downwards, hang the lifting rings, and continue to wind them with the cut pipes. Wind the two round pipes downwards, as shown in the figure.

nine

Take the thick tube at the speed control button of the infusion tube, cut a piece, and cut teeth on both sides, as shown in the figure.

10

Put this toothed plastic piece and beads in the goldfish's eyes.

1 1

The goldfish is ready.