Pattern tying method for tying shoelaces

The mode of tying shoelaces is as follows:

I. cross knots.

1, one end is knotted and the other end is punched in turn;

2. Jump into a hole;

3. fasten it in the same way;

4. After repeating, put the remaining shoelaces into the inside and tie them;

5, purple shoelaces are also punched in order;

6. Wear it from below and then from above;

7. Choose a harmonious shoelace according to the color of the shoes;

8. Extra shoelaces are knotted inside.

Second, trapezoidal knot

1, after adjusting the length of both ends of the shoelace, pull the shoelace from the inside out;

2. Pull out the shoelace and thread it into the second hole from outside to inside;

3. The shoelace on the left goes out from under the shoelace between the two holes on the right, and it is similar on the right;

4. Repeat the operation;

5. Pay attention to the direction of crossing shoelaces at both ends;

6. Extra shoelaces are stuffed into shoes and knotted;

7. Finished trapezoidal knot.

Third, kink

1, two shoelaces are tied inside and released;

2. Two shoelaces cross through the second hole;

3. At this time, in order to center the intersection as much as possible, tighten the shoelaces;

4. The appearance of distortion is produced in the process of intersection pair;

5. An enlarged view of the kink;

6. Leave the last hole;

7. Finally, it is treated with X Ming Kai, which is more convenient to put on and take off;

8. The remaining shoelaces are tied together in the shoes.

Fourth, double X junction.

1, starting from the second hole and passing through the shoelace from outside to inside;

2. First use the X-knot method to make white shoelaces;

3, white X knot;

4. Knot the end inward;

5. As shown in the figure, the blue shoelace passes through the first hole, making an X knot and passing through the intersection of the white shoelace;

6. Tie the end of the blue shoelace;

7. The remaining lines are relatively long and can be made into a circle;

8. Run a few laps and cross the ring.