Weave method of rubber band rainbow bracelet

Rubber band Rainbow bracelet weaving needs rainbow elastic rubber band and abrasive. The specific method is as follows:

1, the arrow of the mold is facing upwards, and a rubber band is covered on it.

2. Tie the rubber bands in this order.

3. The settings are shown in the figure below.

4. Then continue to put on the shape as follows.

5. Then make the rubber band into an "8" shape and pass between these columns, as shown below.

6, according to the graphics on the first floor, make seven such in a row.

7. Turn the mold upside down and wrap the rubber band around the bottom twice.

8. Then use the hook to pull the first rubber band onto the first post on the left.

9. Then hook these rubber bands in the order drawn above and pull them to the next post.

10, and then put all the rubber bands on the next pillar.

1 1, all the settings are shown below.

12, take out a C-shaped buckle and hook the rubber band at the bottom, which is the yellow one in the picture.

13. Pull out the whole bracelet and put it on the hook.

14. At this time, string a single chain and then use a rubber band to pass through the bracelet.

15. If this step is long enough, it can be connected. If it is not long enough, you can continue to put in more rubber bands and then connect them, and a bracelet is finished.