How to make bracelets

1. Put six threads together and tie a knot near a section of about 10 cm. This is temporary, it won't be too tight.

2. Arrange six lines, first tie the knot with the four lines on the right, that is, two knots on one side, two shafts in the middle, and a semi-flat knot below.

3, half a second, that is, the whole flat knot is completed.

4. Repeat steps 2 and 3 in groups of four rows on the left, paying attention to the direction of the tie.

5. Tie a knot with the four lines on the right.

6. When the correct length is maintained, the single knot will begin to be scattered. Note that the direction of the knot should not be wrong and should be consistent.

7. The length of the bracelet is three or four centimeters longer than the wrist. In the process of editing, you can notice that there are two lines, which have been making axes. You can pull the beginning of the two lines a little.