How to use white paper to make a manual

The steps of making a manual with white paper are as follows:

Step 1: First cut the paper, which is twice the size of a single page, and then fold it in half. My white paper is 32k, so this step is cut into 16k. Draw a line with a pencil and cut it with a paper cutter.

Step 2: Divide the paper into two halves. Cut it gently with a paper cutter. Don't push too hard. This step is only for folding 300g paper.

Step 3: Prepare thick needles and threads, and make a point every 3cm for threading. Emphasis: The number of holes must be even.

Step 4: Punch a hole in the point with a needle. Be careful not to prick your hand. If you accidentally prick it, your fingers will be connected and it hurts.

Step 5: Start sewing paper, starting from the first sheet: 1 hole in, 2 holes out, 3 holes in, 4 holes out, 5 holes in and 6 holes out.

Step 6: Continue to make the second picture. The second sheet: 6 holes in and 5 holes out → the first sheet 5 holes in and 4 holes out → the second sheet 4 holes in and 3 holes out.

Step 7: And so on until the second 1 hole comes out. Pay attention to tie a knot with the first coil, which is actually a circle, as long as it is fixed to prevent the notebook from loosening.

Step 8: Just sew all the white paper in.

Step 9: Finally, draw a small picture you like on the cover, and a notebook of your own will be ready.