Origami gun course

The steps of the origami gun are as follows:

1. Take a piece of paper and fold it in half with the symmetry axis.

2. On the basis of one-time folding, take the long axis to fold in half.

3. Four layers of paper strips are obtained in this way, and the above folding steps are repeated once to obtain two paper strips as shown in the figure.

4. Take one of them and fold it in half with the short axis.

5. Wrap the long belt around the short belt at a distance of 1cm.

6. The effect after winding is shown in the figure below. (There will be surplus after the long strip is wound twice, regardless) Fold back one end of the short strip.

7. Collect the remaining piece of paper into the crack.

8. Fold another small piece.

9. Put the extra piece in the crack.

10, and the completion effect is shown in the figure. Repeat the above steps twice to get three basic components.

1 1. Take another piece of paper and split the short axis in two as shown.

12. Repeat the folding method of the basic parts above again, and get a small part, which is the part on the pistol, to be exact, the sight of the gun. The effect is shown in the figure.

13. Take out two of the three large parts and splice them as shown.

14. Splice the third part with the first and second parts as shown in the figure, which is the gun body.

15. Take another piece of paper and roll it into a thin cylinder as shown in the figure. This is the barrel.

16. Pass the barrel through the upper end of the spliced gun body, and the barrel can pass through the other end, subject to the fact that the barrel will not loosen.

17. Take another piece of paper, fold it into a long strip according to the initial steps, and insert the gun handle according to the position shown in the figure. The insertion length is about one centimeter.

18. Fold the strap back and wrap it around the handle.

19. Hide the extra paper in the gap of the gun handle.

20. Now put a small part of the sight into the barrel and move it to the right position. Finally, the spare barrel on the back of the gun can be pinched as the safety of the gun. It's done.