How to adjust the length of steel strip

Method of adjusting the length of metal watchband;

Before removing the watch band, you need to prepare headphones or thimbles, 1mm screwdriver, needle-nosed pliers (light jaws), small hammer, accessory tray, tape measure and magnifying glass (optional).

Note: To avoid scratching the strap, please be careful. Take your time, don't use brute force. At the same time, it is best to take a tape measure and other tools to measure your wrists and braces. So as not to tear it down too much and put it back.

Firstly, the disassembly method of the expansion belt is brought. The first step is to measure the strap, and put the telescopic strap on your wrist to see how many sections overlap. On this basis, add another paragraph to get the number of tapes we want to remove. In fact, the disassembly method of this strap is very simple.

Then remove the cover from the edge of the surface layer. Turn the strap upside down on the table, find the part to be removed, and pull the edge of the strap surface apart.

Then pull open the cover at the bottom edge. Turn the strap over, and in the same way, pull off the layer covering the edge of the strap. When you open the lid on the edge of the surface layer, you will naturally see the lid on the bottom layer.

Remove the excess belt chain and gently slide the belt chain outward, so that the part to be removed can be easily separated.

Finally, reassemble the strap chain. To put the strap back in place, you must clamp both sides of the strap part and then pull back the two covers at the edge.