How to make a doll catcher

The manufacturing method of the doll catcher is as follows:

Method/step 1

Do a good job in the exit panel of the doll clamping machine and the reserved window for people to take out dolls. Recessed slots on both sides are used to install PVC short pipes for transmission. Cut the PVC pipe into proper length and stick it on the card slot with hot melt adhesive. Telescopic claw arm made of ice cream stick and bamboo stick. This toy was launched separately by freebo on May 1 day. It can be used now.

Method/Step 2

The doll clamping machine drives the claws to expand and contract through the hydraulic transmission principle. As shown in the figure, we first fix the needle tube and piston of the syringe at the claw end with hot melt adhesive and cable ties. At this time, if the claw is pulled, the passage of the syringe piston can be adjusted. The transverse plate installed on PVC is used to adjust the front and back direction of claws, and a set of claw hydraulic device controls the left and right movement of claws. Make the front end of the hydraulic claw for catching dolls.

Method/Step 3

Color water is used to transfer the pressure between needle presses, and the needle tube at the control end is uniformly fixed on the bamboo stick console in the front section according to the front, rear, left and right curtain walls and transparent windows of the doll clamping machine. Complete the DIY doll catching machine, mark the direction and purpose of each switch with stickers on the console, and put a small soft clay doll or plastic toy on one side, and you can begin to experience the fun of catching dolls.