Tutorial on various knitting methods of braided rope bracelet

Braided rope bracelet knitting tutorial steps are as follows:

Material preparation: No.5 rope.

1, take 1 line and put it under the green line of the shaft. The chalk line on the right is drawn from the top of the shaft to the left. The purple thread on the left presses the pink thread to prevent the pink thread from coming off. Pull the left end of the bottom line to the right and press it on the red rope.

2. The purple thread is pulled from the shaft to the right, and then a kink is formed. Then pull down the other end of the rope and press it on this end of the rope. The purple thread passes through the coil on the right. Thread the thread from bottom to top.

3. Pick up the thread and tighten it. This forms a 1 knot, and then the left thread is changed first. The red rope on the left bends to the right from the bottom of the short rope and passes through the circle formed by the rope on the right. Take the red rope on the right and bend it to the left. Put it under the red rope on the left.

4. The chalk line on the left is pulled to the right from above the shaft. The purple line on the right is pressing the pink line. The purple line is pulled to the left from under the shaft. With a green line as the center line, fold the longer pink line in half and overlap the purple line. The purple line above is called a line, and the pink line below is called b line. After reaching the required length, prepare to finish, and put the green line into the circle formed by thin lines.

5. The red rope on the left is bent from top to right and placed under the pink rope on the right. The purple rope on the right bends to the left from the bottom of the short rope and passes through the circle on the left. Pass the upper rope under the other rope and out of the ring made of purple thread, which passes through the left coil. Thread the thread from bottom to top and then tighten it.

6. Repeat the above steps all the time, thread the pulled rope out of the loop, and hold both ends of the rope tightly, and repeat the above operations until it is woven into a knot.

7. Every time a 1 knot is formed, it is necessary to change the thread on the other side and start knitting first, and repeat the above operations repeatedly. The order is right line to left line, right line to left line and so on. The knitting method of two-way flat knot and one-way flat knot is similar, but the difference is that one-way flat knot repeats the same step, and the two-way flat knot repeats the step.

The above is the knitting tutorial of braided rope bracelet.