Home-made mineral water bottle watering device Home-made flower watering artifact is as simple as that.

Generally, watering tools are needed to water flowers. But for non-professional flower growers, there is actually no need to buy a flower watering device. You can also make a good flower watering artifact with your own mineral water bottle. It's really not difficult to use mineral water bottles as flower watering devices. Here, the gardener will teach you DIY self-made watering device. Look! The homemade flower watering artifact is as simple as that: mineral water bottle 1 materials and tools to be prepared outside. After preparing materials and tools, open two small holes near the bottom of the mineral water bottle. Pay attention to the size of the hole, as long as you can insert a straw. Not too big, it is best to arrange it up and down, and the opening should not be too far from the bottom of the mineral water bottle. 2. Block the gap between the straw and the small hole with clay or adhesive tape, fix them together and seal them to prevent water from flowing out of the gap. Mineral water bottle flower watering device 3. Bend the straw out of the bottle and trim it into a long one and a short one, with a difference of 2-3 cm. The lower straw is shorter than the upper straw, so that the whole automatic watering device is completed. After all the above steps are completed, just wait for the clay or glue to dry, then fill it with water, and then close the bottle cap tightly, and you can water your favorite flowers. How's it going? Is it simple? Ha ha! The working principle of the flower watering artifact reminds me of the device principle of the self-made flower watering device: two straws, one long and one short, go deep into the sink. When the water level in the sink is lower than the height of the short straw, air will enter the bottle from the short straw, squeeze out the same amount of water, and then flow into the sink from the long straw, thus completing the process of "replenishing water" to plants.