What kinds of knitting methods are there for bracelets?

There are many ways to weave bracelets, such as diamond knot, snake knot, corn knot, flat knot, four-strand braid and so on.

For example:

1. Use four wires, place them side by side and fix one end.

2. Put the middle two lines on both sides.

3. Pinch a set of left and right lines, and put the right one into the left one.

4. Tighten the left sleeve, pull up another thread on the left, pinch a sleeve and enter the right sleeve.

5. Tighten the right sleeve, pull up another thread on the right, pinch a sleeve and enter the left sleeve.

6. Tighten the left sleeve, change the thread on the left, pinch the sleeve and enter the right sleeve. Pay attention to the replaced wire.

7. Tighten the right sleeve, change the thread on the right, pinch the sleeve and enter the left sleeve.

8. Tighten the left sleeve, change the thread on the left, pinch the sleeve and enter the right sleeve.

9. Tighten the right sleeve, change the thread on the right, pinch the sleeve and enter the left sleeve.

10. Repeat steps 8-9 until the required length is reached.

1 1. Finally, the single thread on one side ends in the sleeve on the other side.