What are the methods of making children's handmade umbrellas?

First, we draw two circles, one with white paper and the other with cardboard. White paper is used to draw pictures, and cardboard is used to make umbrellas.

Cut two circles;

Pass the needle through the center point;

Draw an acute angle on the circle and cut it off. After cutting off this corner, let's roll up the cardboard and stick it to the umbrella surface.

Making umbrella ribs

We use toothpicks to make umbrella ribs and stick them together.

1. Brush the glue on the toothpick, and then stick the toothpick to the cardboard with the help of the toothpick.

2. Paste in pairs, * * * 16. So the umbrella rib is finished.

Third, stick a baffle.

At the intersection of the handle and the rib, there is a baffle. This baffle on the umbrella has the function of rain protection and enhanced sealing. Art umbrellas should also be used as baffles, of course, for the sake of shape and beauty.

1. Cut a small disc and pass through the center point;

2. Glue water;

Stick it on the top inside the umbrella. After adding the baffle, the umbrella ribs will look good immediately!

Fourth, the umbrella surface decoration.

1. Draw stick figures against vegetarian dishes;

2. According to the pictures of vegetarian dishes, color them one by one and tick the edges. Finish the pattern of the umbrella cover.

Five, paste decoration

Compare the patterns on the umbrella surface, make a mark, and then draw a straight line with a ruler.

1. Stick double-sided tape along a straight line and cut off the long part;

2. Tear off the non-stick paper on the surface and paste the decorative painting. Then stick it on the umbrella surface. After gluing, scrape it with cardboard, and then paste it.

6. Make an umbrella handle

Umbrella handle, we use iron wire to cover the straw and add three brackets.

1. Cut the straw at the flexible part, compare the length and cut the other end;

2. At the top, pierce three holes from different directions and heights and put on wire. Measure the length and clamp it in a vise. Bend it; 3. The iron wire passes through the top of the umbrella cover, three straws are placed to support the iron wire, and then the ends are bent;

4. The effect after installing the umbrella handle.