Homemade 12 constellation antique bracelet price _ homemade twelve constellation bracelet

How to make antique girlfriends bracelets?

The knitting method of antique girlfriends bracelet is as follows:

Preparation materials: embroidery thread, scissors, beads and pins.

1, pick some favorite embroidery threads. These threads are characterized by being thicker than ordinary sewing threads and having more color choices. Different colors can be used to create a striped effect. Remember, the more shares you use, the wider the bracelet and the more conspicuous the corresponding pattern.

2. Measure the length of the first rope. The length of the thread is slightly longer from the fingertips to the shoulders, and then cut it short.

3. Trim the remaining lines according to the cutting lines. At least 3 strands should be used, but you can choose to use more strands as needed. Generally speaking, 4 to 6 strands of bracelets are thinner, and 8 to 10 strands of bracelets are slightly thicker.

You can choose to use different colors to make bracelets, but you can also use one color repeatedly to make thick stripes of this color. It all depends on the desired visual effect.

5. In the knitting process, you can fix the bracelet on the trousers and use a pin to help keep the position of the thread. Remember to tie a flat knot at the end of all the lines to fix them. There are many ways to fix the bracelet, so you can choose the most suitable way.

6. The most common method is to use a pin to pass through the node and fix it on the trouser leg (or thigh). Remember to make sure the lines don't move on you.

7. Expand the lines from left to right in the order you like. In order to make the nodes look less cumbersome, it is best to arrange the lines in a certain order.

8. In order to make the bracelet more attractive, you can add a few small twists before weaving the pattern. You can also do this at the end. The twist will make the bracelet look more interesting.

9. Wrap the leftmost thread and tie it to the right thread. Specifically, the first strand needs to go around the front of the second strand, then come back from the back, and finally pass through, tightening the end and tying a knot. Repeat the above steps and tie the second knot.

10. When knotting, make sure that the second rope is tight. The first strand is knotted around the second strand, not with the second strand. Then move a flat cable parallel to the right and continue knotting as described above. Eventually you will see a whole line of nodes in this color.

1 1. Repeat the above steps until the bracelet reaches the desired length. You'd better try it on your wrist to make sure it fits. You can put two fingers in it. Because the bracelet may shrink and tighten after soaking in water.

12, and some beads can be added at the end to add extra decorative effect.

13. Tie a flat knot at the soft end of the line. Note that the size of this knot cannot affect the wearability of the bracelet.

Finally, trim the end of the line, and this antique girlfriend bracelet is ready!